Toyota RAV4 Service Manual: Occupant classification system
- Precaution
- System description
- How to proceed with troubleshooting
- Initialization
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Dtc check / clear
- Data list / active test
- Diagnostic trouble code chart
Tc and cg terminal circuit
Description
Dtc output mode is set by connecting terminals tc and cg of the dlc3.
The dtcs are displayed by blinking the srs warning light.
Hint:
Make sure that dtc b1281 has not been output. ...
Precaution
Inspection procedure for vehicle involved
in accident
Perform the zero point calibration and sensitivity
check if any of the following conditions apply.
The occupant classification ...
Other materials:
Installation
Hint:
When installing the spoiler, heat the vehicle body and
spoiler using a heat light.
Standard heating temperature
Notice:
Do not heat the body and spoiler excessively.
Install center stop light
Install the center stop light with the 2 screws.
Install rear spoiler
...
Removal
Hint:
When removing the spoiler, heat the vehicle body and spoiler
using a heat light.
Standard heating temperature
Notice:
Do not heat the vehicle body and spoiler excessively.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
...
Installation
Notice:
Do not heat the vehicle body, emblem and name plate
excessively.
Hint:
When installing the emblem and name plate, heat the vehicle
body, emblem and name plate using a heat light.
Standard heating temperature
Install no. 4 Back door name plate (for 4wd)
Clean the vehicle body ...
