Components
Removal
Disassembly
Inspection
If necessary, repair the cylinder block.
If it does not, replace the relief valve. If necessary, replace the oil pump assembly.
Standard clearance: 0.030 To 0.085 Mm (0.0012 To 0.0033 In.)
Maximum clearance: 0.16 Mm (0.0063 In.)
If the side clearance is greater than the maximum, replace the oil pump assembly.
Standard clearance: 0.080 To 0.160 Mm (0.0031 To 0.0063 In.)
Maximum clearance: 0.35 Mm (0.0138 In.)
If the tip clearance is greater than the maximum, replace the oil pump assembly.
Standard clearance: 0.100 To 0.170 Mm (0.0039 To 0.0067 In.)
Maximum clearance: 0.325 Mm (0.01128 In.)
If the body clearance is greater than the maximum, replace the oil pump assembly.
Maximum chain elongation: 52.4 Mm (2.063 In.)
If the elongation is greater than the maximum, replace the chain.
Hint:
Make the measurements at 3 or more places selected at random.
Notice:
Vernier calipers must contact the chain rollers when measuring.
Minimum sprocket diameter (with chain): crankshaft 48.2 Mm (1.898 In.) Oil pump drive shaft 48.2 Mm (1.898 In.)
If the diameter is less than the minimum, replace the chain and sprockets.
Maximum wear: 0.5 Mm (0.020 In.)
If the wear is greater than the maximum, replace the chain tensioner plate.
Reassembly
Torque: 8.8 N*m (90 kgf*cm, 78 in.*Lbf)
Torque: 49 n*m (500 kgf*cm, 36 ft.*Lbf)
Torque: 8.8 N*m (90 kgf*cm, 78 in.*Lbf)
Installation
Torque: 19 n*m (194 kgf*cm, 14 ft.*Lbf)
Summary of the blind spot monitor
The blind spot monitor is a system that has 2 functions;
The blind spot monitor function
Assists the driver in making the decision when changing lanes
The rear cross traffic alert function
Assists the driver when backing up
These functions use same sensors.
Bsm main switch
...
Camshaft position "a" actuator circuit (bank 1)
Dtc P0010 Camshaft
position "a" actuator circuit (bank
1)
Description
The variable valve timing (vvt) system includes the ecm, ocv and vvt
controller. The ecm sends a
target duty-cycle control signal to the ocv. This control signal regulates the
oil pressure supplied to the ...
Headlight relay circuit
Description
When the light control switch, located on the headlight dimmer switch, is
turned to the head position, the
head relay illuminates the headlights.
Wiring diagram
Inspection procedure
Perform active test by intelligent tester (headlight)
Connect the intelligent tester ( ...