If any of the defects mentioned above are present, replace the front seat with a new one.
Caution:
For removal and installation procedures of the front seat side airbag, be sure to follow the correct procedure.
Inspection
Inspect rear stabilizer link assembly lh
As shown in the illustration, move the ball joint stud
back and forth 5 times before installing the nut.
Using a torque wrench, turn the nut continuously at
a rate of 3 to 5 seconds per turn and take the torque
reading on the fifth turn.
...
Throttle / pedal position sensor
Hint:
These dtcs relate to the accelerator pedal position (app) sensor.
Description
Hint:
This etcs (electronic throttle control system) does not use a throttle cable.
The app sensor is mounted on the accelerator pedal bracket and has 2 sensor
circuits: vpa (main) and
vpa2 (sub). This ...
Reassembly
Install evaporator temperature sensor
Notice:
If reusing the evaporator, do not insert the sensor to
a location where the sensor was previously inserted.
Insert the sensor within range c shown in the
illustration.
Install the evaporator temperature sensor as shown
in the illustrati ...