Toyota RAV4 Service Manual: On-vehicle inspection
Notice:
- Perform the maf meter inspection according to the
procedures below.
- Only replace the maf meter when both the long
ft#1 value and maf value in the data list (with the
engine stopped) are not within the normal operating
range.
- Inspect mass air flow meter
- Perform confirmation driving pattern.
- Connect the intelligent tester to the dlc3.
- Turn the ignition switch on.
- Turn the tester on.
- Clear the dtcs (see page es-35).
- Start the engine and warm it up with all
accessory switches off until the engine
coolant temperature is 75°c (167°f) or more.
- Drive the vehicle at 50 km/h (31 mph) or more
for 3 to 5 minutes*1.
- Allow the engine to idle for 2 minutes*2.
- Perform steps *1 and *2 at least 3 times.
- Read the value using the intelligent tester (long
ft#1).
- Select the following menu items: diagnosis /
enhanced obd ii / data list / primary /
long ft#1.
- Read the values displayed on the tester.
Standard value:
within -15 to +15%
If the result is not within the specified range,
perform the inspection below.
- Read the value using the intelligent tester (maf).
Notice:
- Turn off the engine.
- Perform the inspection with the vehicle
indoors and on a level surface.
- Perform the inspection of the maf meter
while it is installed to the air cleaner case
(installed to the vehicle).
- During the test, do not use the exhaust air
duct to perform suction on the exhaust pipe.
- Turn the ignition switch to acc.
- Turn the ignition switch on (do not run the
engine).
- Turn the tester on.
- Select the following menu items: diagnosis /
enhanced obd ii / data list / primary /
maf.
- Wait 30 seconds, and read the values on the
intelligent tester.
Standard condition:
less than 0.45 G/sec.
- If the result is not as specified, replace the
maf meter.
- If the result is within the specified range,
inspect the cause of the extremely rich or
lean air-fuel ratio (see page es-147).
Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensi ...
Other materials:
Rear combination light assembly
Components
Removal
Hint:
Use the same procedures for the rh and lh sides.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal t ...
Abs control system malfunction
Description
This dtc is output when the vsc system detects a malfunction in the abs
system.
Inspection procedure
Check dtc for abs system
Clear the dtc (see page bc-47).
Turn the ignition switch on.
Check if the same dtc is recorded (see page bc-47).
Result
Repair ...
Using the radio
Power
Volume
Adjusting the frequency
Scanning for receivable stations
Am/fm mode button
Station selectors
Seeking the frequency
Displaying text message
Setting station presets
Search for the desired stations by turning the ¢Â§tune¢escroll¢¸
knob or ...