Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: On-vehicle inspection

  1. Check accelerator pedal rod

Toyota RAV4. Check accelerator pedal rod


  1. Check the voltage.
  1. Connect the intelligent tester to the dlc3.
  2. Turn the ignition switch on
  3. Turn the intelligent tester on.
  4. Select the menu items: diagnosis / enhanced obd ii / data list / all / accel pos #1, accel pos #2.
  5. Operate the accelerator pedal, and then check that the accel pos #1 and accel pos #2 values are within the specifications.

Standard voltage (accel pos #1)


Standard voltage (accel pos #2)


If the result is not as specified, check the accelerator pedal rod, wire harness or ecm.

Accelerator pedal rod
Components ...

Removal
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt preten ...

Other materials:

Opening and closing procedures
The power windows can be opened and closed using the switches. Operating the switch moves the windows as follows: Closing One-touch closing (driver’s window only) (if equipped)* Opening One-touch opening (driver’s window only)* *: To stop the window partway, operate the ...

Data list / active test
Active test Hint: Performing the intelligent tester active test allows relay, vsv, actuator and other items to be operated without removing any parts. Performing the active test early in troubleshooting is one way to save time. The data list can be displayed during the active test. ...

Front brake
Components Removal Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. Remove front wheel Drain brake fluid Notice: Wash off brake fluid immediately if it comes in contact with any painted surface. Disconnec ...

© 2011-2026 Copyright www.trav4.net