Notice:
If the battery is weak or if the engine is difficult to start, perform the following procedures.
Hint:
Before checking the battery voltage, turn off all the electrical systems (headlights, blower motor, rear defogger, etc.).
Standard specific gravity: 1.25 To 1.29 At 20°c (68°f)
If the electrolyte quantity is above the lower line, check the battery voltage when cranking the engine. If the voltage is less than 9.6 V, recharge or replace the battery.
Hint:
Before checking the battery voltage, turn off all the electrical systems (headlights, blower motor, rear defogger, etc.).
(1) Check that the battery terminals are not loose or corroded.
Standard resistance: below 1
If the results are not as specified, replace the fuses as necessary.
If any defects are found, replace the v-ribbed belt.
Hint:
Cracks on the rib side of the belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.
Hint:
Confirm by hand that the belt has not slipped out of the grooves on the bottom of the pulley.
If the light does not operate as specified, troubleshoot the charge warning light circuit.
Standard amperage: 10 a or less
Standard voltage: 12.1 To 15.4 V
If the result is not as specified, replace the generator.
Hint:
If the battery is not fully charged, the ammeter reading will sometimes be more than the standard amperage.
Standard amperage: 30 a or more
If the ammeter reading is less than the standard amperage, repair the generator.
Hint:
If the battery is fully charged, the indication will sometimes be less than the standard amperage. If this is the case, add more electrical load (operate the wipers, rear window defogger, etc.) And check the reading on the ammeter again.
Customize parameters
Hint:
The following items can be customized.
Notice:
When the customer requests a change in a function,
first make sure that the function can be customized.
Be sure to make a note of the current settings before
customizing.
When troubleshooting a function, first make sure that
the fu ...
Front passenger occupant classification system
Your vehicle is equipped with a front passenger occupant classification
system. This system detects the conditions of the front
passenger seat and activates or deactivates the devices for the
front passenger.
Seat belt reminder light
Srs warning light
“Air bag off” indicator light ...
Fail-safe chart
Fail safe operation
If there is a problem with any sensor signals or
actuator systems, the skid control ecu prohibits the
power supply to the abs and traction actuator
and informs the ecm of vsc system failure.
The abs and traction actuator turns off the
solenoids and the ecm sh ...