Toyota RAV4 manuals

Toyota RAV4 Service Manual: On-vehicle inspection

  1. Inspect refrigerant pressure with manifold gauge set

  1. This method uses a manifold gauge set to locate problem areas. Read the manifold gauge pressure when these conditions are established. Test conditions:

Toyota RAV4. On-vehicle inspection


 Toyota RAV4. On-vehicle inspection


  1. Normally functioning refrigeration system

Gauge reading v

  1. The a/c system periodically changes between normal and improper function due to moisture in the refrigerant system.

Toyota RAV4. On-vehicle inspection


  1. The a/c system does not function effectively due to insufficient cooling.

Toyota RAV4. On-vehicle inspection


  1. The a/c system does not function effectively due to poor circulation of the refrigerant.

Toyota RAV4. Refrigerant


  1. The a/c system does not function intermittently because the refrigerant does not circulate.

Toyota RAV4. On-vehicle inspection


  1. The a/c system does not function effectively due to overcharged refrigerant or insufficient cooling of the condenser.

Toyota RAV4. On-vehicle inspection


  1. The a/c system does not function due to air in the refrigeration system.

Caution:

The low-pressure piping may be very hot and cause serious burns.

Toyota RAV4. On-vehicle inspection


  1. The a/c system does not function effectively due to an expansion valve malfunction.

Toyota RAV4. On-vehicle inspection


Toyota RAV4. On-vehicle inspection


  1. The a/c system does not function due to a defective compressor.

Toyota RAV4. On-vehicle inspection


Refrigerant
...

Replacement
discharge refrigerant from refrigeration system Start up the engine. Turn the a/c switch on. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 min ...

Other materials:

On-vehicle inspection
Check driver side seat belt warning light Turn the ignition switch on. When the driver side seat belt is not fastened, check that the combination meter's driver side seat belt warning light starts blinking. When the seat belt is fastened, check that the combination meter's driver ...

Inspection
Inspect crankshaft position sensor Measure the resistance of the sensor. Standard resistance Notice: Cold and hot mean the temperature of the coils themselves. Cold is from -10 to 50°c (14 to 122°f) and hot is from 50 to 100°c (122 to 212°f). If the result is not as specif ...

Removal
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and ...

© 2011-2024 Copyright www.trav4.net