Toyota RAV4 manuals

Toyota RAV4 Service Manual: Only driver door lock / unlock functions do not operate

Toyota RAV4 Service Manual / Door lock / Power door lock control system / Data list / active test / Only driver door lock / unlock functions do not operate

Description

The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly.

Wiring diagram

Toyota RAV4. Only driver door lock / unlock functions do not operate


Inspection procedure

  1. Perform active test by intelligent tester (door lock)

  1. Select the active test, use the intelligent tester to generate a control command, and then check that the doors lock / unlock.

Toyota RAV4. Perform active test by intelligent tester (door lock)


Ok: doors can lock / unlock



  1. Read value of intelligent tester (lock position switch)

  1. Use the data list to check if the door lock is functioning properly.

Toyota RAV4. Read value of intelligent tester (lock position switch)


Ok: when the door lock is operating, the intelligent tester should display as shown in the table.



  1. Inspect front door with motor lock assembly lh

Toyota RAV4. Inspect front door with motor lock assembly lh


  1. Apply the battery voltage to the motor terminals and check the operation of the door lock motor.

Ok


  1. Measure the resistance of the door lock position switch.

Standard resistance




  1. Check wire harness (door lock - ecu)

Toyota RAV4. Check wire harness (door lock - ecu)


  1. Disconnect the h5 door lock connector.
  2. Disconnect the e15 ecu connector.
  3. Disconnect the ih junction block connector.
  4. Measure the resistance of the wire harness side connectors.

Standard resistance




Replace instrument panel junction block (main body ecu)

All doors cannot be locked / unlocked simultaneously
Description The main body ecu receives switch signals from the door control switch on the power window regulator master switch, door control switch and driver side door key cylinder, and activat ...

Only passenger door lock / unlock functions do not operate
Description The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly. Wiring diagram Inspection procedure Read value of intelligent tester (lo ...

Other materials:

Reassembly
Caution: Wear protective gloves. Sharp areas on the seatback frame, seat cushion frame and reclining adjuster may injure your hands. Hint: A bolt without a torque specification is shown in the standard bolt chart (see page ss-2). Install rear seat cover lh Attach the 2 claws to i ...

Glossary of sae and toyota terms
This glossary lists all sae-j1930 terms and abbreviations used in this manual in compliance with sae recommendations, as well as their toyota equivalents. ...

Mass or volume air flow circuit
Description The mass air flow (maf) meter is a sensor that measures the amount of air flowing through the throttle valve. The ecm uses this information to determine the fuel injection time and to provide the appropriate air-fuel ratio. Inside the maf meter, there is a heated platinu ...

В© 2011-2024 Copyright www.trav4.net