Toyota RAV4 manuals

Toyota RAV4 Service Manual: Only passenger door lock / unlock functions do not operate

Toyota RAV4 Service Manual / Door lock / Power door lock control system / Data list / active test / Only passenger door lock / unlock functions do not operate

Description

The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly.

Wiring diagram

Toyota RAV4. Only passenger door lock / unlock functions do not operate


Inspection procedure

  1. Read value of intelligent tester (lock position switch)

  1. Use the data list to check if the door lock is functioning properly.

Toyota RAV4. Read value of intelligent tester (lock position switch)


Ok: when the door lock is operating, the intelligent tester should display as shown in the table.



  1. Inspect front door with motor lock assembly rh

Toyota RAV4. Inspect front door with motor lock assembly rh


  1. Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

Ok


  1. Measure the resistance of the door lock position switch.

Standard resistance



  1. Check wire harness (door lock - ecu)

Toyota RAV4. Check wire harness (door lock - ecu)


  1. Disconnect the g5 door lock connector.
  2. Disconnect the e15 ecu connector.
  3. Disconnect the ih junction block connector.
  4. Measure the resistance of the wire harness side connectors.

Standard resistance



Replace instrument panel junction block (main body ecu)

Only driver door lock / unlock functions do not operate
Description The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly. Wiring diagram Inspection procedure Perform active test by intelligent t ...

Only rear door lh lock / unlock functions do not operate
Description The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly. Wiring diagram Inspection procedure Inspect rear door with motor lock as ...

Other materials:

Power seat switch
Inspection Inspect front power seat switch Measure the resistance between the terminals when each switch is operated. Standard resistance Slide switch Front vertical switch Lifter switch Reclining switch If the result is not as specified, replace the switch. ...

Outside vehicle
General maintenance Performing the following maintenance checks on the vehicle is the owner's responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tools are not requ ...

Communication
Description The skid control ecu sends signals such as cruise control cancel demand signals and brake operation demand from ecm response signals to the ecm when the cruise control system is in operation. Inspection procedure Hint: This circuit uses can communication. Therefore, if t ...

В© 2011-2024 Copyright www.trav4.net