Description
The solenoid relay supplies power to the abs solenoid and trc solenoid.
After the ignition switch is turned on, the vehicle speed has reached 6 km/h (4 mph) and the solenoid is determined to be normal by the initial check self-diagnosis, the relay switches on. If any open or short circuits are detected, the relay switches off.
These dtcs may be set if the voltage supply to the solenoid relay (+bs) falls below the dtc detection threshold due to the battery or alternator outputs being insufficient.
Hint:
Dtcs c0278/11 and c0279/12: the skid control ecu begins to detect these dtcs when the vehicle speed exceeds 6 km/h (4 mph).
Wiring diagram
Refer to dtc c0273/13, c0274/14, c1361/91 (see page bc-79).
Inspection procedure
Standard resistance: below 1
Standard voltage
Standard resistance
Result
Replace abs and traction actuator assembly
Reassembly (2006/01- )
Install drive shaft bearing case subassembly
(for rh)
Install the bearing snap ring.
Using sst and a press, press in the drive shaft
bearing case to the inboard joint rh.
Sst 09527-10011, 09710-04081
Notice:
The bearing should be installed completely.
Using a snap rin ...
Axle system
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column of
the table. Check each symptom by checking the suspected
areas in the order th ...
Ignition coil
Description
Hint:
These dtcs indicate malfunctions relating to the primary circuit.
If dtc p0351 is set, check no. 1 Ignition coil with igniter circuit.
If dtc p0352 is set, check no. 2 Ignition coil with igniter circuit.
If dtc p0353 is set, check no. 3 Ignition coil with igniter cir ...