Turning the end of the lever turns on the lights as follows:
Type a
(When the engine switch is in the “on” position [vehicles without a smart key system] or ignition on mode [vehicles with a smart key system])
The daytime running
lights turn on.
Type b
Type c
Rear wiper motor
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove back door center garnish (see page
ed-59)
...
Occupant classification sensor power supply circuit malfunction
Description
The occupant classification sensor power supply circuit consists of the
occupant classification ecu and
the occupant classification sensors.
Dtc b1793 is recorded when a malfunction is detected in the occupant
classification sensor power
supply circuit.
Wiring diagram
...
Door control receiver
Components
Removal
Remove rear door scuff plate rh
Using a screwdriver, detach the 9 claws.
Hint:
Tape the screwdriver tip before use.
Using a clip remover, detach the 2 clips and remove
the garnish.
Remove rear door opening trim
weatherstrip rh
...