Toyota RAV4 Service Manual: Operation check
- Inspect driver side seat belt warning light
- Turn the ignition switch on.
- When the driver seat belt is not fastened, check that the driver seat belt warning light on the combination meter blinks.
- When the driver seat belt is fastened, check that the driver seat belt warning light on the combination meter is off
- Inspect passenger side seat belt warning light (for automatic air conditioning system)
- Turn the ignition switch on.
- When the front passenger seat belt is not fastened with the passenger seat occupied, check that the front passenger seat belt warning light on the heater control panel display blinks.
- When the front passenger seat belt is fastened with the passenger seat occupied, check that the front passenger seat belt warning light on the heater control panel display is off.
- Remove passenger side seat belt warning light (for manual air conditioning system)
- Turn the ignition switch on.
- When the front passenger seat belt is not fastened with the passenger seat occupied, check that the front passenger seat belt warning light on the clock panel blinks.
- When the front passenger seat belt is fastened with the passenger seat occupied, check that the front passenger seat belt warning light on the clock panel is off.
- Inspect seat belt warning buzzer
Hint:
If the buzzer does not sound, the buzzer cancel setting may be set to on.
- Turn the ignition switch on.
- When the vehicle is driven at approximately 20 km/h (12.4 Mph) or more while the driver or front passenger seat belt is not fastened, check that the buzzer in the combination meter sounds at 1.2 Second intervals for 30 seconds.
- 30 Seconds after the buzzer has first sounded, check that the buzzer sounds at 0.4 Second intervals for 90 seconds.
- 120 Seconds after the buzzer has first sounded, check that the buzzer stops
- After the buzzer has stopped, turn the ignition switch off and then start the engine again. Drive the vehicle at approximately 25 km/h (16 mph) or more while the driver or front passenger seat belt is not fastened, and then check that the buzzer sounds again.
- After the buzzer has stopped, fasten the driver and front passenger seat belts. Drive the vehicle at approximately 25 km/h (16 mph) or more and unfasten the driver or front passenger seat belt, and then check that the buzzer sounds again.
- After the buzzer has stopped, move the shift lever to
the r position, and then move it to the d position.
Drive the vehicle at approximately 25 km/h (16 mph) or more, and then check that the buzzer sounds again.
How to proceed with troubleshooting
Hint:
Use these procedures to troubleshoot the seat belt
warning system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltage:
...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column
of th ...
Other materials:
Fail-safe chart
If a problem occurs in the electric power steering system, the
p/s warning light will come on in the combination meter and
steering power assist will be stopped, fixed at a particular
point, or decreased simultaneously to protect the system.
Hint:
The amount of power assist may be decreased ...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Re ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Disconnect cable from positive battery
terminal
Remove battery clamp
...
