Problem symptoms table
Hint:
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Adjustment
Ok: 7 to 9 clicks (without rear brake dragging)
Ok: 7 to 9 clicks (without rear brake dragging) <lever pulling force: approximately 200 n (20 kgf, 44 lbf)>
Torque: 6.0 N*m (61 kgf*cm, 53 in.*Lbf)
Ok: 7 to 9 clicks (without rear brake dragging) <lever pulling force: approximately 200 n (20 kgf, 44 lbf)>
Standard condition: brake warning light always illuminates at the first click.
Open in stop light switch circuit
Description
The skid control ecu detects the brake operating conditions through a signal
transmitted by the stop light
switch. The skid control ecu incorporates an open circuit detection circuit.
This dtc is set under either of
the following conditions:
An open is detected in the stop lig ...
Positioning a floor jack
When raising your vehicle with a floor jack, position the jack correctly.
Improper placement may damage your vehicle or cause
injury.
Front
Rear
Caution
When raising your vehicle
Make sure to observe the following precautions to reduce the possibility of
death or serious injury:
...
Parts location
System diagram
...