Studies have shown that installing a child restraint on a rear seat is much safer than installing one on the front passenger seat.
General installation instructions are provided in this manual.
Disassembly
Inspect oil pump assembly (see page ax-218)
Remove clutch drum oil seal ring
Remove the 2 clutch drum oil seal rings.
Remove stator shaft assembly
Using a t30 ''torx'' socket, remove the 11 bolts and
stator shaft. Keep the gears in assembling order.
Inspect clearan ...
Propeller shaft assembly
Components
Removal
Remove propeller shaft with center bearing
shaft assembly
Remove the 2 bolts and 2 adjusting washers, and
disconnect the propeller with center bearing shaft.
Notice:
During the removal, do not exert excessive
force on the universal joint.
When r ...
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
When installing the moulding, heat the vehicle body and
moulding using a heat light.
Standard heating temperature
Notice:
Do not heat the vehicle body and moulding
excessively ...