Description
This dtc is output when the sliding roof drive gear (sliding roof ecu) has not been initialized.
Wiring diagram
Refer to dtc b2341 (see page rf-11).
Inspection procedure
Ok: sliding roof drive gear can be initialized.
Ok: auto operation operates normally with slide open and tilt up switch.
End
Standard resistance
Standard resistance
Replace sliding roof drive gear sub-assembly (sliding roof ecu)
Installation
Install knock sensor
Install the sensor with the nut.
Torque: 20 n*m (205 kgf*cm, 15 ft.*Lbf)
Notice:
Make sure that the knock sensor is in the
correct position.
Connect the sensor connector.
Install intake manifold insulator
install the intake manifold insulat ...
Front suspension lower no. 1 Arm
Components
Removal
Remove front wheel
Remove hood sub-assembly
Remove the hood (see page ed-4).
Suspend engine assembly
Install the no. 1 And no. 2 Engine hangers with the
bolts as shown in the illustration.
Torque: 38 n*m (387 kgf*cm, 28 ft.*Lbf)
parts no.
...
Trailer tongue weight
A recommended tongue weight varies in accordance with the types
of trailers or towing as described below.
To ensure the recommended values shown below, the trailer must
be loaded by referring to the following instructions.
Tongue weight
The gross trailer weight should be distributed so ...