Toyota RAV4 (XA40) 2013-2018 Owners Manual: Power back door switch (vehicles with a power back door)
Pressing the switch closes the back door automatically. (A buzzer sounds.)
Pressing the switch while the back door is opening/closing stops the operation. Pressing the switch again will reverse the operation.
Opening the back door from outside the vehicle
Back door opener
Vehicles without a power
back door
Raise the back door while
pressing up the back door
opener switch.
Vehicles with a power back
door
When the back door is
unloc ...
When closing the back door
Lower the back door using the
back door handle.
Vehicles without a power back
door
Make sure to push the back door
down from the outside to close it.
Vehicles with a power back
door
...
Other materials:
Definition of terms
Terms
Definition
Monitor description
Description of what ecm monitors and how detects malfunctions
(monitoring purpose and
details).
Related dtcs
Group of diagnostic trouble codes that are output by ecm based on
same malfunction
detection logic.
...
Occupant classification sensor power supply circuit malfunction
Description
The occupant classification sensor power supply circuit consists of the
occupant classification ecu and
the occupant classification sensors.
Dtc b1793 is recorded when a malfunction is detected in the occupant
classification sensor power
supply circuit.
Wiring diagram
...
Diagnostic trouble code chart
Hint:
Parameters listed in the chart may be different than your
readings depending on the type of instrument and other
factors.
If any dtcs are displayed during a check mode dtc check,
check the circuit for the dtcs listed in the table below. For
details of each dtc, refer to the page indica ...
