The power outlet can be used for 12 v accessories that run on less than 10 a.
Open the lid.
The power outlets can be used when
The engine switch is in the “acc” or “on” position.
The engine switch is in accessory or ignition on mode.
Notice
To avoid damaging the power outlets
Close the power outlet lids when the power outlets are not in use.
Foreign objects or liquids that enter the power outlets may cause a short circuit.
To prevent the fuse from being blown
Do not use an accessory that uses more than 12 v 10 a.
To prevent battery discharge
Do not use the power outlets longer than necessary when the engine is not running.
Throttle actuator control motor circuit
Description
The throttle actuator is operated by the ecm and opens and closes the
throttle valve using gears.
The opening angle of the throttle valve is detected by the throttle position (tp)
sensor, which is mounted
on the throttle body. The tp sensor provides feedback to the ecm. This ...
Diagnosis system
Description
When troubleshooting on-board diagnostic (obd
ii) vehicles, the vehicle must be connected to the
obd ii scan tool (complying with sae j1987).
Various data output from the vehicle's ecm can
then be read.
Obd ii regulations require that the vehicle's onboard
computer ...
Inspection
Inspect generator brush holder assembly
Using a vernier caliper, measure the brush length.
Standard length:
9.5 To 11.5 Mm (0.374 To 0.453 In.)
Minimum length:
4.5 Mm (0.177 In.)
If the brush length is less than the minimum, replace
the generator brush holder assembly.
Inspe ...