Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Power steering

Parking brake assembly
Components Disassembly Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. Remove rear wheel Disconnect rear disc brake cyli ...

Electronic power steering system
...

Other materials:

Vin not programmed or mismatch - ecm / pcm
Description Dtc p0630 is set when the vehicle identification number (vin) is not stored in the engine control module (ecm) or the input vin is incorrect. Input the vin with the intelligent tester. Monitor strategy Typical enabling conditions Typical malfunction thresholds Com ...

On-vehicle inspection
Connect intelligent tester Connect the intelligent tester to the dlc3. Start the engine and idle it. Select the active test mode on the intelligent tester. Hint: Please refer to the intelligent tester operator's manual for further details. Check actuator motor operation ...

Heated oxygen sensor
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove heated oxygen sensor (for bank 1 sensor 2) ...

В© 2011-2026 Copyright www.trav4.net