Toyota RAV4 Service Manual: Power steering ecu
Components
Removal
- Disconnect cable from negative battery terminal
- Remove instrument panel sub-assembly upper
- Remove the instrument panel (see page ip-4).
- Remove power steering ecu
- Disconnect the 4 connectors.
- Remove the 3 nuts and remove the power steering ecu.
Installation
- Install power steering ecu
- Install the power steering ecu with the 3 nuts.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*Lbf)
- Connect the 4 connectors.
- Install instrument panel sub-assembly upper
- Install the instrument panel (see page ip-9).
- Connect cable to negative battery terminal
Steering gear
Components
Removal
Position front wheels facing straight
ahead
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable f ...
Propeller shaft
...
Other materials:
Torque converter and drive plate
Inspection
Inspect torque converter clutch assembly
Inspect the one-way clutch.
Install sst to the inner race of the one-way
clutch.
Sst 09350-32014 (09351-32010)
Set sst so that it fits in the notch of the
converter hub and in the outer race of the oneway
clutch.
...
Air conditioning control panel does not operate
Description
This circuit consists of the air conditioning control and the air
conditioning amplifier. When the air
conditioning control is operated, signals are transmitted to the air
conditioning amplifier through the lin
communication system.
If the lin communication system malfunctions, ...
Fail-safe chart
Fail-safe function
When communication fails in any of the main wires
(communication lines) due to a short circuit or other
causes, the fail-safe function, which is specified for
each system, operates to prevent the system from
malfunctioning.
The table below shows the effects on e ...
