Description
If the power steering ecu detects these dtcs, it shuts off the motor relay circuit (built into the power steering ecu) and stops power assist.
Inspection procedure
Ok: dtc is not output.
Replace power steering ecu
Open in abs solenoid relay circuit
Description
The solenoid relay supplies power to the abs solenoid and trc solenoid.
After the ignition switch is turned on, the vehicle speed has reached 6 km/h (4
mph) and the solenoid is
determined to be normal by the initial check self-diagnosis, the relay switches
on. If any open or ...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Re ...
Battery current sensor circuit
Description
The battery current sensor installed on the positive (+) battery terminal
detects the amount of current
supplied from the generator.
The battery current sensor changes current to voltage (at the positive (+)
battery terminal) and sends it to
the ecm. The ecm controls th ...