Toyota RAV4 manuals

Toyota RAV4 Service Manual: Precaution

  1. If any of following conditions are met, keep engine idling with a/c on (engine speed at less than 2000 rpm) for at least 1 minute:

Notice:

If the engine speed exceeds 2,000 rpm, the a/c compressor may be damaged.

  1. Do not handle refrigerant in enclosed areas or near open flames

  2. Always wear eye protection

Toyota RAV4. Always wear eye protection


  1. Be careful not to get liquid refrigerant in your eyes or on your skin

Toyota RAV4. Be careful not to get liquid refrigerant in your eyes or on your skin


If liquid refrigerant gets in your eyes or on your skin:

  1. Wash the area with lots of cold water.

Caution:

Do not rub your eyes or skin.

  1. Apply clean petroleum jelly to the skin.
  2. Go immediately to a physician or hospital for professional treatment.
  1. Never heat container or expose it to open flame

  2. Be careful not to drop container or subject it to physical shocks

  3. Do not operate compressor with insufficient refrigerant in refrigerant system

Toyota RAV4. Do not operate compressor with insufficient refrigerant in refrigerant system


If there is not enough refrigerant in the refrigerant system, oil lubrication will be insufficient and compressor burnout may occur. Necessary care should be taken to avoid this.

  1. Do not open high pressure manifold valve while compressor is operating

Open and close only the low pressure valve. Opening and closing the high pressure valve could cause the charging cylinder to rupture.

  1. Be careful not to overcharge system with refrigerant

If the refrigerant is overcharged, it causes problems such as insufficient cooling, poor fuel economy and engine overheating.

  1. Do not operate engine and compressor without refrigerant

Notice:

This may damage the inside of the compressor.

Air conditioning system (for manual air conditioning system)
...

Parts location (2005/11-2006/01)
...

Other materials:

Front power seat lumbar switch
Inspection Inspect front power seat lumbar switch lh Measure the resistance between the terminals when the switch is operated. Standard resistance If the result is not as specified, replace the switch. ...

On-vehicle inspection
Check steering pad assembly (vehicle not involved in collision and airbag not deployed) Perform a diagnostic system check (see page rs- 49). With the steering pad (with airbag) installed on the vehicle, perform a visual check: check for cuts, cracks or discoloration on the ...

Installation
Caution: Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1). Install steering pad assembly Support the steering pad with one hand as shown in the illustration. Connect the 2 airbag connectors. Notice: When handling t ...

В© 2011-2024 Copyright www.trav4.net