Toyota RAV4 Service Manual: Precaution
- Handling precaution for cruise control system
- Turn the cruise control main switch off when not using the cruise control system.
- Be careful as the vehicle speed increases when driving downhill with the cruise control system on.
- The resume/accel operation changes according to the cruise control system status. When the cruise control system is operating, accel operates. When the cruise control system is not operating, resume operates.
- When the cruise control system is operating and the cruise main indicator light blinks, turn the cruise control main switch off to reset the cruise control system. After the reset, if the cruise control main switch cannot be turned on, or the cruise control system is canceled immediately after turning the cruise control main switch on, the system may have a malfunction.
- Do not use the cruise control system where the road conditions are as follows:
- Heavy traffic
- Steep downhill
- Roads with sharp turns
- Icy or snowy roads
- Slippery roads
Parts location
System diagram
System description
Cruise control system
This system is controlled by the ecm, and is activated by
the throttle position sensor and motor. The ecm controls
the ...
Other materials:
Downhill assist control switch
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove downhill assist control switch
Detach t ...
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove roof rack support sub-assembly center
Remove the 4 roof carrier caps and roof rack
support center.
Remove roof rack bar front
Remove the 4 screws ...
Front shock absorber with coil spring
Components
Removal
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Remove front wheel
Disconnect front speed sensor lh
Disconnect front stabilizer link assembly
lh
Remove front shock absorber with coil spring lh
...
