Toyota RAV4 (XA40) 2013-2018 Service Manual: Pressure sensor circuit
Description
This dtc is output when the refrigerant pressure is either extremely low (0.19 Mpa [2.0 Kgf/cm2, 28 psi] or less) or extremely high (3.14 Mpa [32.0 Kgf/cm2, 455 psi] or more). The air conditioning pressure sensor, which is installed on the pipe of the high pressure side, detects the refrigerant pressure and sends refrigerant pressure signals to the air conditioning amplifier. The air conditioning amplifier determines the pressure from the signals in accordance with the sensor characteristics, and controls the compressor accordingly.
Wiring diagram
Inspection procedure
- Check refrigerant
- Check the sight glass of the cooler unit refrigerant liquid pipe.
- Prepare the vehicle in accordance with the chart
below.
- Compare the sight glass to the following chart.
Hint:
*: If the ambient temperature is higher than usual but cooling is sufficient, bubbles in the sight glass are permissible.
- Read value of intelligent tester (reg press sens)
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on and turn the intelligent tester main switch on.
- Select the item below in the data list, and read the value displayed on the intelligent tester.
Ok: the display is as specified in the normal condition column.
- Check wire harness (pressure sensor - air conditioning amplifier)
- Disconnect the a21 pressure sensor connector.
- Disconnect the e36 amplifier connector.
- measure the resistance of the wire harness side connectors.
Standard resistance 
- Check air conditioning amplifier
- Remove the air conditioning amplifier with its connectors still connected.
- Measure the resistance of the wire harness side connector
Standard resistance 
- Turn the ignition switch on.
- Measure the voltage of the wire harness side connector.
Standard voltage 
- Inspect air conditioning pressure sensor
- Turn the a/c switch on.
- Disconnect the a21 sensor connector.
- Connect the three 1.5 V dry cell batteries' positive (+)
lead to terminal 3 and the negative (-) lead to terminal 1.
Then connect the voltmeter's positive (+) lead to terminal 2 and the negative (-) lead to terminal 1. Measure the voltage.
Ok: the voltage changes in accordance with the refrigerant pressure as shown in the graph.
Replace air conditioning amplifier
Compressor lock sensor circuit
Description
This sensor sends 1 pulse per engine revolution to the air conditioning
amplifier. If the ratio of the
compressor speed divided by the engine speed is smaller than a predetermined ...
Compressor solenoid circuit (2005/11-2006/01)
Description
In this circuit, the compressor receives a refrigerant compression demand
signal from the air conditioning
amplifier. Based on this signal, the compressor changes the degree of
r ...
Other materials:
Changing the display
The multi-information display is
operated using the meter control
switches.
Scroll the screen*/switch the
display*/move the cursor
Press: Enter/Set
Press and hold: Reset/Display
customizable items
Return to the previous screen
Call sending/receiving and
history display (if equipped)
Linke ...
Antenna coil open / short
Description
The transponder key coil receives key code signals from the transponder chip
in the key grip. The coil
built into the transponder key amplifier amplifies the key code signals and
outputs the signal to the
transponder key ecu.
Wiring diagram
Inspection procedure
R ...
For safe driving
For safe driving, adjust the
seat and mirror to an appropriate
position before driving.
Correct driving posture
Adjust the angle of the seatback
so that you are sitting
straight up and so that you do
not have to lean forward to
steer.
Adjust the seat so that you
can depress the pedals full ...
