Hint:
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
On-vehicle inspection
Maximum free play: 30 mm (1.18 In.)
If the free play exceeds the maximum, replace the steering intermediate shaft sub-assembly or steering gear.
Repair
Hint:
Look at the upper surface of the steering wheel, the steering spokes and the srs airbag line to determine the center position.
Hint:
Hint:
Electronic power steering: 1 turn (360Щ of rack end (1.5 Mm (0.059 In.) Horizontal movement) - 10.8РOf steering angle.
Torque: 88 n*m (897 kgf*cm, 65 ft.*Lbf)
Notice:
Make sure that the difference in length between the rh and lh tie rod ends and rack end screws is less than 1.5 Mm (0.059 In.).
Pressure control solenoid "A " performance (shift solenoid valve sl1)
Description
The ecm uses signals from the vehicle speed sensor to detect the actual gear
position (1st, 2nd, 3rd or
o/d gear).
Then the ecm compares the actual gear with the shift schedule in the ecm memory
to detect mechanical
problems of the shift solenoid valves, valve body or automatic ...
Propeller shaft assembly
Components
Removal
Remove propeller shaft with center bearing
shaft assembly
Remove the 2 bolts and 2 adjusting washers, and
disconnect the propeller with center bearing shaft.
Notice:
During the removal, do not exert excessive
force on the universal joint.
When r ...
Brake pedal load sensing switch
On-vehicle inspection
Inspect brake pedal load sensing switch
Hint:
Do not remove the brake pedal load sensing switch
from the brake pedal support.
When there is a malfunction in the brake pedal load
sensing switch, replace the brake pedal support.
Disconnect the brake pedal l ...