Toyota RAV4 Service Manual: Push switch / key unlock warning switch malfunction
Description
This dtc is output if the transponder key ecu does not detect that the unlock warning switch is on even when the ignition switch is on. Under normal conditions, the unlock warning switch is on when the ignition switch is on.
Wiring diagram
Inspection procedure
- Read value of intelligent tester (unlock warning switch)
- Connect the intelligent tester (with can vim) to the dlc3.
- Turn the ignition switch on with a key that cannot start the engine.
- On the intelligent tester, enter the following menus: diagnosis / obd/mobd / immobiliser / data list / key sw. Read the result.
Ok: on (key is in ignition key cylinder) appears on the screen.
- Inspect unlock warning switch assembly
- Remove the unlock warning switch.
- Measure the resistance of the switch.
Standard resistance 
- Check wire harness (unlock warning switch - body ground)
- Disconnect the e6 switch connector.
- Measure the resistance of the wire harness side connector.
Standard resistance 
- Check wire harness (unlock warning switch - transponder key ecu)
- Disconnect the e6 switch connector.
- Disconnect the e46 ecu connector.
- Measure the resistance of the wire harness side connectors.
Standard resistance 
Replace transponder key ecu
Antenna coil open / short
Description
The transponder key coil receives key code signals from the transponder chip
in the key grip. The coil
built into the transponder key amplifier amplifies the key code signals and
...
Other materials:
Evaporative emission control system incorrect purge flow
Dtc summary
Description
The description can be found in the evap (evaporative emission) system (see
page es-335).
Inspection procedure
Refer to the evap system (see page es-340).
Monitor description
The two monitors, key-off and purge flow, are used to detect malfunctions
relating ...
Rear view monitor
system
The rear view monitor system assists the driver by displaying an
image of the view behind the vehicle and fixation guide lines
while backing up, for example while parking.
The screen illustrations used in this text are intended as examples,
and may differ from the image that is actually displaye ...
Vehicle speed sensor "A"
description
The speed sensor detects the wheel speed and sends the appropriate signals to
the skid control ecu.
The skid control ecu converts these wheel speed signals into a 4-pulse signal
and outputs it to the ecm
via the combination meter. The ecm determines the vehicle speed based o ...
