Components
On-vehicle inspection
Maximum backlash: 0.05 Mm (0.0020 In.)
If the backlash is greater than the maximum, replace the axle hub.
Maximum deviation: 0.08 Mm (0.0031 In.) For 2wd
0.06 Mm (0.0024 In.) For 4wd
Notice:
If the runout exceeds the maximum, change the installation positions of the rear disc and axle hub so that the runout will be as low as possible. If the runout exceeds the maximum even when the installation positions are changed, shave the rear disc. If the rear disc needs to be shaved to less than the minimum, replace the rear disc. If the rear disc is replaced, perform the runout inspection again. If the runout still exceeds the maximum, replace the hub and bearing with a new one.
Removal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Sst 09930-00010
Notice:
Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.
Notice:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.
Notice:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.
Installation
Torque: 90 n*m (918 kgf*cm, 68 ft.*Lbf)
Notice:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.
Torque: 90 n*m (918 kgf*cm, 68 ft.*Lbf)
Notice:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.
Torque: 216 n*m (2,203 kgf*cm, 159 ft.*Lbf)
Torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)
Installation (2005/11-2006/01)
Install sliding roof weatherstrip
Install the sliding roof weatherstrip.
Position the joint of the weatherstrip at the rear
center.
Align the marks on the weatherstrip with the
middle marks at the corners of the plastic on
the edge of the sliding roof panel and install the ...
Precaution
Notice:
Take extra care to replace each part properly. Improper
installation or repair could affect the performance of
the brake system and cause a driving hazard.
It is very important to keep the brake system parts and
the work area clean when repairing the brake system.
If the vehicl ...
Downhill assist control switch
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove downhill assist control switch
Detach t ...