Toyota RAV4 manuals

Toyota RAV4 Service Manual: Rear axle hub bolt

Toyota RAV4 Service Manual / Axle / Rear axle hub bolt

Components

Toyota RAV4. Rear axle hub bolt


Replacement

Hint:

  1. Remove rear wheel

  2. Remove rear disc brake cylinder assembly lh (see page br-55)

  3. Remove rear disc (see page br-57)

  4. Remove rear axle hub bolt

Toyota RAV4. Remove rear axle hub bolt


  1. Using sst and a brass bar or equivalent to hold the axle shaft, remove the hub bolt that needs to be replaced.

Sst 09650-17011

  1. Install rear axle hub bolt

Toyota RAV4. Install rear axle hub bolt


  1. Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.
  2. Using a brass bar or equivalent to hold the rear axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer
  1. Install rear disc (see page br-58)

  2. Install rear disc brake cylinder assembly lh (see page br-61)

  3. Install rear wheel torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)

Front axle hub
Components (2005/11-2006/01) Components (2006/01- ) On-vehicle inspection Check front axle hub bearing Remove the front wheel. Disconnect the front disc brake cylinder (see p ...

Rear axle hub and bearing
Components On-vehicle inspection Remove rear wheel Disconnect rear drive shaft assembly lh (for 4wd) Disconnect the drive shaft (see page ds-69). Remove rear disc brake cy ...

Other materials:

Antenna coil open / short
Description The transponder key coil receives key code signals from the transponder chip in the key grip. The coil built into the transponder key amplifier amplifies the key code signals and outputs the signal to the transponder key ecu. Wiring diagram Inspection procedure R ...

Checking monitor status
Perform monitor drive pattern Connect the intelligent tester to the dlc3. Turn the ignition switch and the tester on. Clear the dtcs (see page es-35). Run the vehicle in accordance with the applicable drive pattern described in readiness monitor drive pattern (see page es-19). Do ...

Diagnosis system
Diagnosis If the skid control ecu detects a malfunction, the abs, vsc and brake warning lights and the slip, downhill assist control and auto lsd indicator lights come on in accordance with the trouble area to warn the driver. The table below indicates which lights come on when there ar ...

В© 2011-2024 Copyright www.trav4.net