Toyota RAV4 manuals

Toyota RAV4 Service Manual: Rear brake flexible hose

Toyota RAV4 Service Manual / Brake / Rear brake flexible hose

Installation

Hint:

  1. Install rear brake tube flexible hose

Notice:

The gasket and union bolt must be used as a set, as shown in the illustration.

Toyota RAV4. Install rear brake tube flexible hose


  1. Connect the flexible hose with new gasket(s) and the union bolt to the disc brake cylinder.

Torque: 30.4 N*m (310 kgf*cm, 22 ft.*Lbf)

Toyota RAV4. Install rear brake tube flexible hose


Hint:

Install the flexible hose lock securely in the lock hole in the cylinder.

  1. Set the flexible hose to the connecting point with the brake tube (labeled a), and then attach a new clip (labeled b).
  2. Using sst, connect the flexible hose to the brake tube (labeled a) while holding the flexible hose with a wrench.

Toyota RAV4. Install rear brake tube flexible hose


Sst 09023-00101

Torque: 15.2 N*m (155 kgf*cm, 11 ft.*Lbf) without sst

14 N*m (144 kgf*cm, 10 ft.*Lbf) with sst

Hint:

Use a torque wrench with a fulcrum length of 30 cm (11.81 In.).

Notice:

  1. Fill reservoir with brake fluid (see page br- 6)

  2. Bleed air from brake master cylinder (see page br-7)

  3. Bleed air from brake line (see page br-7)

  4. Bleed air from abs and traction actuator assembly (see page br-8)

  5. Check brake fluid level in reservoir (see page br-6)

  6. Check for brake fluid leakage

  7. Install rear wheel torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)

Brake rear brake flexible hose
Components Removal Hint: Use the same procedures for the lh side and rh side. The procedures listed below are for the lh side. Remove rear wheel Drain brake fluid Notice: Wash ...

Parking brake system
Problem symptoms table Hint: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected ...

Other materials:

Data list / active test
Read data list Hint: Using the intelligent tester's data list allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the data list early in troubleshooting is one way to save time. Connect the intelligent tester to the dlc3. Turn the igni ...

Precaution
If any of following conditions are met, keep engine idling with a/c on (engine speed at less than 2000 rpm) for at least 1 minute: Refrigerant gas has been refilled or a/c parts have been replaced. A long time has elapsed since the engine was stopped. Notice: If the engine s ...

Throttle / pedal position sensor / switch "A"
Hint: These dtcs relate to the throttle position (tp) sensor. Description The tp sensor is mounted on the throttle body, and detects the opening angle of the throttle valve. This sensor is a non-contact type. It uses hall-effect elements in order to yield accurate signals even in extrem ...

В© 2011-2024 Copyright www.trav4.net