Toyota RAV4 Service Manual: Rear differential side gear shaft oil seal
Components
Removal
- Drain differential oil (see page df-10)
- Remove tailpipe assembly
- Remove the tailpipe (see page ex-2).
- Remove center exhaust assembly
- Remove propeller with center bearing
shaft assembly (see page pr-3)
- Remove rear differential carrier subassembly
(see page df-18)
- Remove rear differential side gear shaft oil seal
- Using a sst, tap out the 2 oil seals.
Sst 09308-00010
Installation
- Install rear differential side gear shaft oil seal
- Apply a light coat of mp grease to the lip of a new
rear differential side gear shaft oil seal.
- Using sst and a hammer, tap the 2 rear differential
side gear shaft oil seals into the rear differential
carrier and differential side bearing retainer
according to the specification.
Sst 09223-00010
Standard oil seal tapping amount (a value):
7.2 +-0.5 Mm (0.28 +-0.02 In.)
- Install rear differential carrier
assembly (see page df-44)
- Temporarily install propeller with
center bearing shaft assembly (see page
pr-5)
- Tighten propeller with center bearing
shaft assembly (see page pr-6)
- Inspect and adjust joint angle (see page pr-
4)
- Install center exhaust pipe assembly
- Install the center pipe (see page ex-5).
- Install tailpipe assembly
- Install the tailpipe (see page ex-6).
- Add differential oil
- Add differential oil (see page df-3).
- Check for differential oil leakage
- Check for exhaust gas leakage
If gas is leaking, tighten the areas necessary to stop the
leak. Replace damaged parts as necessary.
On-vehicle inspection
Check differential oil
Stop the vehicle on a level surface.
Using a 10 mm socket hexagon wrench, remove the
rear differential filler plug and gasket.
...
Components
Removal
Drain differential oil
Using a 10 mm socket hexagon wrench, remove the
rear differential drain plug and gasket, and drain the
oil.
Install a new gasket to t ...
Other materials:
Room temperature sensor (for automatic ai conditioning system)
Components
Removal
Remove lower instrument panel
Remove the lower instrument panel (see page ip-
16).
Remove room temperature sensor
Disconnect the duct.
Disconnect the connector.
Detach the claws and remove the sensor.
Inspection
Inspect room temperature ...
Installation
Caution:
Be sure to read the precautionary notices concerning the
srs airbag system before servicing it (see page rs-1).
Install front passenger airbag assembly
Attach the rear side hook of the front passenger
airbag to the rear side airbag door.
Bend the front side hook so that it a ...
Hydraulic test
Measure line pressure
Notice:
Perform the test at the normal operating atf
temperature: 50 to 80°c (122 to 176°f).
The line pressure test should always be
performed with at least 2 people. One person
should observe the condition of the wheels or
wheel chocks while the other ...