Components
Removal
Hint:
Hint:
While fixing the nut in place, loosen and remove the bolt from the suspension member side.
Sst 09610-20012
Notice:
Do not damage the dust cover.
Inspection
Standard turning torque: 3.4 N*m (35 kgf*cm, 30 in.*Lbf)
Installation
Hint:
Torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)
Torque: 90 n*m (918 kgf*cm, 66 ft.*Lbf) for bolt 100 n*m (1,020 kgf*cm, 74 ft.*Lbf) for nut
Notice:
For the nut on the rear suspension member side, do not tighten the nut.
Registering a bluetooth®
phone for the first time
To use the hands-free system, it is necessary to register a
bluetooth® phone with the system.
Once the phone has been registered, it is possible to use the
hands-free system.
For details about registering a bluetooth® device
Turn the bluetooth® connection setting of your cellular phon ...
Dtc check / clear
Check dtc
Connect the intelligent tester (with can vim) to the
dlc3.
Turn the ignition switch on and turn the intelligent
tester on.
Read the dtc by following the prompts on the
tester screen.
Hint:
Refer to the intelligent tester operator's manual for
further details.
...
Removal
(2006/01- )
Remove front wheel
Drain automatic transaxle fluid
Drain the automatic transaxle fluid for u140f (see
page ax-147).
Drain the automatic transaxle fluid for u241e (see
page ax-146).
Drain the automatic transaxle fluid for u151e (see
page ax-172).
Remove front axle hub nut ( ...