Components
Removal
Hint:
Notice:
Place a wooden or rubber block between the jack and the arm.
Installation
Hint:
Notice:
Install the arm so that the coil spring's distinguishing mark is on the outer side of the vehicle.
Torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)
Torque: 90 n*m (918 kgf*cm, 66 ft.*Lbf)
Notice:
Do not tighten the nuts.
Fuel tank cap
Inspection
Inspect fuel tank cap assembly
Visually check that the cap and gasket are not
deformed or damaged.
If the result is not as specified, replace the cap
assembly or gasket.
Remove the gasket from the exhaust manifold.
...
Power steering ecu communication stop mode
Description
Wiring diagram
Inspection procedure
Notice:
Turn the ignition switch off before measuring the resistances of the
main wire and the branch
wire.
After the ignition switch is turned off, check that the key reminder
warning system and light
reminder warning system ...
Cooling fan motor
On-vehicle inspection
Inspect no. 1 Cooling fan motor
Disconnect the no. 1 Fan connector.
Connect the battery and ammeter to the no. 1 Fan
motor connector.
Check that the no. 1 Fan rotates smoothly, and then
check the reading on the ammeter.
Standard amperage ...