Toyota RAV4 Service Manual: Rear wiper rubber
Components
Removal
- Remove rear wiper blade assembly
- Rotate and remove the cap as described in the "remove" procedures.
- Raise the arm and blade.
- Raise the wiper blade to the position where the claw detach with a ''click'' sound, as shown in the illustration.
Notice:
Be careful not to damage the claw.
- Pull the wiper blade straight toward the left side of the vehicle to remove it from the wiper arm.
Notice:
Do not fold the wiper arm with the wiper blade removed. The arm tip may damage the back door glass surface.
- Remove rear wiper rubber
- Lift and pull the end of the wiper rubber protruding from the blade stopper as shown in the illustration.
Notice:
Do not forcibly pull out the wiper rubber. The backing plates will be deformed or the blade claws will be damaged.
Hint:
Lightly pushing the rubber between the ends and middle will allow it to be removed more easily.
Installation
- Install rear wiper rubber
- Install the no. 1 And no. 2 Backing plates as shown in the illustration.
Notice:
Install the backing plates facing the correct direction.
- Insert the wiper rubber from the front end of the wiper blade to the rear end through the second claw.
- After pushing the wiper rubber through the rear end claw, allow it to stick out from the rear end stopper.
- Slide the wiper rubber through the front end claw.
- Install rear wiper blade assembly
- Push the wiper blade straight toward the right side of the vehicle to install it to the wiper arm.
- Lower the arm and blade.
- Rotate and install the cap.
Rear wiper motor
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Wiper switch
Precaution
Precaution for vehicle with srs
Some procedures in this section may affect the
supplemental restraint system (srs). Prior to
performing the procedures, read the srs section's
...
Other materials:
Inspection
Inspect starter assembly
Notice:
These tests must be performed within 3 to 5 seconds
to avoid burning out the coil.
Perform the pull-in test.
Disconnect the lead wire from terminal c.
Connect the battery to the magnetic switch as
shown in the illustration. Check that the clutch ...
Passenger side buckle switch circuit malfunction
Description
The passenger side buckle switch circuit consists of the occupant
classification ecu and the front seat
inner belt rh.
Dtc b1771 is recorded when a malfunction is detected in the passenger side
buckle switch circuit.
Troubleshoot dtc b1771 first when dtcs b1771 and b1795 ...
Assist grips
An assist grip installed on the ceiling
can be used to support your
body while sitting on the seat.
Caution
Assist grip
Do not use the assist grip when getting in or out of the vehicle or
rising from
your seat.
Doing so could damage the assist grip, or could cause you to injure yourse ...
