Hint:
Sst 09201-41020
Hint:
The intake valve oil seal is gray and the exhaust valve oil seal is black.
Notice:
Pay close attention when installing the intake and exhaust oil seals. For example, installing the intake oil seal into the exhaust or installing the exhaust oil seal to the intake can cause installation problems later.
Sst 09202-70020 (09202-00010)
Notice:
Be careful not to damage the valve stem tip.
Sst 09202-70020 (09202-00010)
Notice:
Be careful not to damage the valve stem tip.
Notice:
Install the valve lifters in their original places.
Clean the contact surface of the bearing and the bearing cap.
Notice:
Do not apply engine oil to the contact surfaces of the camshaft bearing and bearing cap.
Notice:
Do not apply engine oil to the contact surfaces of the camshaft bearing and cylinder block.
Torque: 9.0 N*m (92 kgf*cm, 80 in.*Lbf)
Sst 09817-33190
Torque: 20 n*m (204 kgf*cm, 15 ft.*Lbf)
Adhesive: toyota genuine adhesive 1344, three bond 1344 or equivalent
Torque: 13 n*m (133 kgf*cm, 10 ft.*Lbf)
Torque: 10 n*m (102 kgf*cm, 7 ft.*Lbf)
Vacuum switching valve
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove purge vsv
Disconnect the purge vsv ...
Monitor drive pattern
Test monitor drive pattern for ect
Caution:
Perform this drive pattern on a level surface and
strictly observe the posted speed limits and traffic
laws while driving.
Hint:
Performing this drive pattern is one method to simulate
the ect's malfunction detection conditions.
The dtcs may ...
Heated oxygen sensor
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove heated oxygen sensor (for bank 1 sensor 2)
...