Toyota RAV4 Service Manual: Reassembly
- Install front oil pump oil seal
- Using sst and a hammer, install a new oil seal to the pump.
Sst 09350-32014 (09351-32140)
Hint:
The seal end should be flat with the outer edge of the oil pump.
- Coat the lip of the oil seal with petroleum jelly.
- Install front oil pump body o-ring
- Coat the new o-ring with atf, and install it to the oil pump body.
- Install front oil pump driven gear
- Coat the front oil pump driven gear with atf, and install it to the oil pump body with the marked side facing up.
- Install front oil pump drive gear
- Coat the front oil pump drive gear with atf, and install it to the oil pump body with the marked side facing up.
- Install stator shaft assembly
- Set the stator shaft by aligning each bolt hole.
- Using a t30 ''trox'' socket, install the 11 bolts.
Torque: 9.8 N*m (100 kgf*cm, 87 in.*Lbf)
- Install clutch drum oil seal ring
- Install the 2 clutch drum oil seal rings.
Notice:
Do not expand the ring ends excessively.
- Inspect oil pump assembly (see page ax-218)
Inspection
Inspect oil pump assembly
Turn the drive gear with 2 screwdrivers and make
sure it rotates smoothly.
Notice:
Be careful not to damage the oil seal lip.
Inspect clearance of oil ...
Second brake piston
Components
Disassembly
Remove 2nd brake piston return spring sub-assembly
Place sst on the return spring and compress.
Using a screwdriver, pry out the snap ring.
Remove the pis ...
Other materials:
Oxygen (a/f) sensor pumping current circuit
Description
Refer to dtc p2195 (see page es-292).
Monitor description
The air-fuel ratio (a/f) sensor varies its output voltage in proportion to
the air-fuel ratio. If the a/f sensor
impedance (alternating current resistance) or output voltage deviates greatly
from the standard range ...
Reassembly
Hint:
Use high-temperature grease to lubricate the bearings,
gears, return spring and steel ball when assembling the
starter.
Install planetary gear
Apply grease to the planetary gears and pin parts of
the planetary shaft.
Install the 3 planetary gears.
Install starter arm ...
Transmitter id
Description
The tire pressure warning valve and transmitter that is installed in the
tires and wheels measures the air
pressure of the tires. The measured values are transmitted to the tire pressure
warning receiver on the
body as radio waves and then sent to the tire pressure warning ecu ...
