Description
Wiring diagram
Inspection procedure
Notice:
It is necessary to register an id code after replacing the tire pressure warning valve abd transmitter and/or the tire pressure warning ecu (see page tw-9).
Hint:
Set the tire pressure to the specified value.
Standard pressure: 220 kpa (2.2 Kgf/cm2, 32 psi)
Standard voltage
Standard resistance
Ok: dtc is not output.
Hint:
End
Standard resistance
Replace tire pressure warning ecu
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
sensor, actuator and other item values to be read without
removing any parts. Reading the data list early in
troubleshooting is one way to save time.
Connect the intelligent tester (with can vim) to the
...
Pressure sensor circuit
Description
This dtc is output when the refrigerant pressure is either extremely low
(0.19 Mpa [2.0 Kgf/cm2, 28 psi]
or less) or extremely high (3.14 Mpa [32.0 Kgf/cm2, 455 psi] or more). The air
conditioning pressure
sensor, which is installed on the pipe of the high pressure side, detec ...
Brake master cylinder
Components
On-vehicle inspection
Check brake fluid level warning switch
Remove the reservoir filler cap and strainer.
Disconnect the brake fluid level warning switch
connector.
Measure the resistance of the switch.
Hint:
There is a float inside the reservoir. Its positio ...