Toyota RAV4 Owners Manual: Registering a bluetooth® device
Bluetooth® compatible phones (hfp) and portable audio players (avp) can be registered simultaneously. You can register up to 5 bluetooth® devices.
How to register a bluetooth® device
- Display the “bluetooth* setup” screen.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
- Select “add”.
- When this screen is displayed, search for the device name displayed on this screen on the screen of your bluetooth® device.
For details about operating the bluetooth® device, see the manual that comes with it.
To cancel the registration, select “cancel”.
- Register the bluetooth® device using your bluetooth® device.
A pin-code is not required for ssp (secure simple pairing) compatible bluetooth® devices. Depending on the type of bluetooth® device being connected, a message confirming registration may be displayed on the bluetooth® device’s screen. Respond and operate the bluetooth® device according to the confirmation message.
- Check that this screen is displayed when registration is complete.
- Select “ok” when the connection status changes from “connecting...” To “connected”.
If an error message is displayed, follow the guidance on the screen to try again.
Registration can be performed from screens other than the “bluetooth* setup” screen.
When registering from the “bluetooth* audio” screen
- Display the “bluetooth* audio” screen
- Select “select device”.
- Follow the steps in “how to registering a bluetooth® device” from 2
*: Bluetooth is a registered trademark of bluetooth sig, inc.
Deleting a bluetooth® device
- Display the “bluetooth* setup” screen.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
- Select “remove”.
- Select the desired device.
- A confirmation message will be displayed, select “yes” to delete the device.
- Check that a confirmation screen is displayed when the operation is complete.
Registering a bluetooth®
phone for the first time
To use the hands-free system, it is necessary to register a
bluetooth® phone with the system.
Once the phone has been registered, it is possible to use the
hands-free system.
For details abou ...
Connecting a bluetooth®
device
Up to 5 bluetooth® devices (phones (hfp) and audio players
(avp)) can be registered.
If more than 1 bluetooth® device has been registered, select
which device to connect to.
Press the “se ...
Other materials:
Ig power supply voltage malfunction
Description
The power steering ecu distinguishes the ignition switch status as on or off
through the ig power
source circuit.
Wiring diagram
Inspection procedure
Read value of intelligent tester (ig power supply)
Connect the intelligent tester (with can vim) to the
dlc3.
...
Registration
Notice:
The vehicle identification number (vin) must be input
into the replacement ecm.
Hint:
The vin is a 17-digit alphanumeric number. The intelligent
tester is required to register the vin.
Description
This registration section consists of 3 parts: input
instructions, read vin and wr ...
Problem symptoms table (2005/11-2006/01)
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms are
listed in order of probability in the "suspected area" column of
the table. Check each symptom by checking the suspected
areas in the order they are listed. Replace p ...
