Toyota RAV4 Service Manual: Registration
Notice:
The vehicle identification number (vin) must be input into the replacement ecm.
Hint:
The vin is a 17-digit alphanumeric number. The intelligent tester is required to register the vin.
- Description
This registration section consists of 3 parts: input instructions, read vin and write vin.
- Input instructions: explains the general vin input instructions when using the intelligent tester.
- Read vin: explains the vin reading process in a flowchart. This process allows the vin stored in the ecm to be read in order to confirm that the two vins, provided with the vehicle and stored in the vehicle's ecm, are the same.
- Write vin: explains the vin writing process in a flowchart. This process allows the vin to be input into the ecm. If the ecm is changed, or the vehicle vin and ecm vin do not match, the vin can be registered or overwritten in the ecm by following this procedure.
- Input instructions
- Intelligent tester
The arrow buttons (up, down, right and left) and numerical buttons (0 to 9) are used to input the vin.
- Cursor operation
To move the cursor around the tester screen, press the right and left buttons.
- Alphabetical character input
- Press the up and down buttons to select the desired alphabetical character.
- After selection, the cursor should move.
- Numeric character input
- Press the numerical button corresponding to the number that you want to input.
- After input, the cursor should move.
Hint:
Numerical characters can also be selected by using the up and down buttons.
- Correction
- When correcting the input character(s), put the cursor onto the character using the right and left buttons.
- Select or input the correct character using the up/down buttons, or the numerical buttons.
- Finishing input operation
- Make sure that the input vin matches the vehicle vin after input.
- Press the enter button on the tester.
- Read vin
- Confirm the vehicle vin.
- Connect the intelligent tester to the dlc3.
- Turn the ignition switch on.
- Turn the tester on.
- Select the following menu items: diagnosis / enhanced obd ii/ vin.
- Write vin
- Confirm the vehicle vin.
- Connect the intelligent tester to the dlc3.
- Turn the ignition switch on.
- Turn the tester on.
Select the following menu items: diagnosis / enhanced obd ii/ vin.
Basic inspection
When a malfunction is not confirmed by the dtc check,
troubleshooting should be carried out in all circuits
considered to be possible causes of the problem. In many
cases, by carrying out the basic ...
Checking monitor status
Perform monitor drive pattern
Connect the intelligent tester to the dlc3.
Turn the ignition switch and the tester on.
Clear the dtcs (see page es-35).
Run the vehicle in accordance with ...
Other materials:
Torque converter clutch solenoid circuit
Description
The shift solenoid valve dsl is turned on and off by signals from the ecm to
control the hydraulic
pressure acting on the lock-up relay valve, which then controls operation of the
lock-up clutch.
Fail-safe function:
if the ecm detects a malfunction, it turns the shift sol ...
Registration
Perform vehicle stability control system recognition in ecm
Notice:
If the vehicle has both cruise control and vsc, when
replacing ecm, perform vsc recognition as follows:
Turn the ignition switch on.
After waiting approximately 5 seconds, turn the
cruise control main switch on.
Ke ...
Parking brake lever
Components
On-vehicle inspection
Check parking brake switch assembly
Remove the rear console box (see page ip-16).
Hint:
Refer to the procedures from the removal of the no.
1 Console upper panel garnish up until the removal
of the rear console box sub-assembly.
Discon ...
