Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Registration

  1. In case of tire pressure warning ecu replacement

  1. Read id stored in the old ecu using the intelligent tester.
  1. In case of tire pressure warning valve and transmitter and/or tire pressure warning ecu replacement

  1. Read the id written on the tire pressure monitor valve.
  1. Register transmitter id

Toyota RAV4. Register transmitter id


Notice:

It is necessary to register the transmitter id in the tire pressure warning ecu when replacing the tire pressure warning valve and transmitter and/or tire pressure warning ecu.

  1. Prepare all of the transmitter id data before starting registration.

Hint:

Toyota RAV4. Register transmitter id


  1. Connect the intelligent tester (with can vim) to the dlc3.
  2. Turn the ignition switch on.
  3. *1: Read and write down the id (id1 to id5) by using the data list.

Toyota RAV4. Register transmitter id


  1. *2: Select regist tire set following the intelligent tester screen (utility - regist tire set).
  2. *3: Select the registration mode "main".

Toyota RAV4. Register transmitter id


  1. Input the id (id1 to id5) using the intelligent tester and transmit it to the tire pressure warning ecu.
  2. Set the id transmission condition to "id registration is complete".

Toyota RAV4. Register transmitter id


Hint:

  1. Confirmation of transmitter id registration

  1. Set the tire pressure of all wheels (including the spare tire) to the specified value.

Standard pressure: 220 kpa (2.2 Kgf/cm2, 32 psi)

  1. Connect the intelligent tester (with can vim ) to the dlc3.
  2. Turn the ignition switch on.
  3. Select "signal check" mode on the intelligent tester (with can vim ) (see page tw-12).
  4. Confirm that the transmitter ids and tire pressure data for all the tires are displayed on the intelligent tester screen.

Notice:

How to proceed with troubleshooting
Hint: Use these procedures to troubleshoot the tire pressure warning system. *: Use the intelligent tester. Vehicle brought to workshop Inspect battery voltage Standard volta ...

Test mode procedure
Test mode check Hint: When entering the test mode, the tire pressure warning ecu sets all the test dtcs first. After completing the test mode for each inspection item, the dtcs that ar ...

Other materials:

Diagnostic trouble code chart
If a dtc is displayed during the dtc check, check the circuit listed in the table below and proceed to the page given. Hint: *1: "Comes on" means the malfunction indicator lamp (mil) illuminates. *2: "Dtc stored" means the ecm memorizes the malfunction code if the ecm ...

Inspection
Inspect generator brush holder assembly Using a vernier caliper, measure the brush length. Standard length: 9.5 To 11.5 Mm (0.374 To 0.453 In.) Minimum length: 4.5 Mm (0.177 In.) If the brush length is less than the minimum, replace the generator brush holder assembly. Inspe ...

If your vehicle has to be stopped in an emergency
Only in an emergency, such as if it becomes impossible to stop the vehicle in the normal way, stop the vehicle using the following procedure: Steadily step on the brake pedal with both feet and firmly depress it. Do not pump the brake pedal repeatedly as this will increase the effort req ...

В© 2011-2024 Copyright www.trav4.net