Toyota RAV4 Service Manual: Registration
- Perform vehicle stability control system recognition in ecm
Notice:
If the vehicle has both cruise control and vsc, when replacing ecm, perform vsc recognition as follows:
- Turn the ignition switch on.
- After waiting approximately 5 seconds, turn the cruise control main switch on.
- Keep the cruise control main switch on for approximately 5 seconds or more.
Hint:
The vsc recognition will not be reflected in the cruise control system until the ignition switch is turned off and on.
Road test
Inspect set switch
Push the main switch on.
Drive at a desired speed (40 km/h (25 mph) or
higher).
Inspect "+" switch
Push the main switch button on.
D ...
Problem symptoms table
Hint:
Use the table below to help determine the cause of the
problem symptom. The potential causes of the symptoms
are listed in order of probability in the "suspected area"
column ...
Other materials:
Low pitched horn
Components
Removal
Remove radiator support opening cover
(see page et-4)
Remove front fender liner lh (see page et-4)
Remove front fender liner rh (see page et-4)
Remove front bumper cover (see page et-5)
Remove low pitched horn
Disconnect the horn connector.
Remove th ...
Transmission control cable assembly
Replacement
Remove rear console box sub-assembly
Remove the console box (see page ip-20).
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pre ...
Removal
Caution:
Be sure to read the precautionary notices concerning the
srs airbag system before servicing it (see page rs-1).
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent air ...
