Toyota RAV4 Service Manual: Removal
Hint:
- Use the same procedures for the rh side and lh side.
- The procedures listed below are for the rh side.
- Remove front seat headrest assembly
- Remove front seat assembly
- Operate the power seat switch knob and move the
seat to the foremost position.
- Using a screwdriver, detach the 2 claws.
Hint:
Tape the screwdriver tip before use.
- remove the front seat track bracket outer cover in
the direction indicated by the arrow in the
illustration.
- Using a screwdriver, detach the 2 claws.
Hint:
Tape the screwdriver tip before use.
- Remove the front seat track bracket inner cover in
the direction indicated by the arrow in the
illustration.
- Remove the 2 bolts on the rear side of the seat.
- Operate the power seat switch knob and move the
seat to the rearmost position.
- Remove the 2 bolts on the front side of the seat.
- Operate the power seat switch knob and move the
seat to the center position. Then, operate the power
seat switch knob and move the seatback to the
upright position.
- Disconnect the cable from the negative (-) battery
terminal.
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner
activation.
- Disconnect the connectors under the seat. Then
remove the seat.
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the rh side.
Install front seat assembly
Place the seat in the cabin.
Notice:
Be ca ...
Caution:
Wear protective gloves. Sharp areas on the seat frame
(with adjuster) may injure your hands.
Remove reclining power seat switch knob
Using a screwdriver, detach the knob.
H ...
Other materials:
Battery current sensor
On-vehicle inspection
Check battery current sensor assembly
Measure the resistance of the sensor.
Standard resistance
If the result is not as specified, replace the sensor
assembly.
Measure the resistance of the sensor.
Standard resistance
If the result is not as specified, ...
Brake pedal load sensing switch
On-vehicle inspection
Inspect brake pedal load sensing switch
Hint:
Do not remove the brake pedal load sensing switch
from the brake pedal support.
When there is a malfunction in the brake pedal load
sensing switch, replace the brake pedal support.
Disconnect the brake pedal l ...
Selecting shift ranges in the s position
To enter s mode, shift the shift lever to s. Shift ranges can be selected
by operating the shift lever, allowing you to drive in the shift range of
your choosing. The shift range can be selected by the shift lever.
Upshifting
Downshifting
The selected shift range, from 1 to
6, will be di ...