Toyota RAV4 manuals

Toyota RAV4 Service Manual: Removal

Hint:

  1. Remove no. 2 Seat hinge cover lh

Toyota RAV4. Remove no. 2 Seat hinge cover lh


  1. Fully tilt the seatback forward.
  2. Attach the 2 claws and clip.

Toyota RAV4. Remove no. 2 Seat hinge cover lh


  1. Pull the hinge cover in the direction indicated by the arrow in the illustration to detach the 2 claws. Then, remove the hinge cover.
  1. Remove no. 2 Seat leg cover lh

Toyota RAV4. Remove no. 2 Seat leg cover lh


  1. Using a screwdriver, detach the 5 claws and remove the leg cover.

Hint:

Tape the screwdriver tip before use.

  1. Remove rear no. 2 Seat assembly

Toyota RAV4. Remove rear no. 2 Seat assembly


  1. Remove the nut and rear seat cushion wire.
  2. Remove the 2 bolts. Then disconnect the seat from the rear no. 2 Seat link.

Toyota RAV4. Remove rear no. 2 Seat assembly


  1. Remove the 2 nuts and the rear no. 2 Seat link.

Toyota RAV4. Remove rear no. 2 Seat assembly


  1. Pull the lock release band backward and release the 3 seat cushion locks from the lock strikers.
  2. Lift up and remove the seat.

Notice:

Be careful not to damage the vehicle body,

  1. Remove rear no. 1 Floor mat support side plate

  2. Remove no. 2 Seat leg box protector.

Toyota RAV4. Remove no. 2 Seat leg box protector.


  1. Using a clip remover, remove the clip.
  2. Detach the clip. Then remove the protector.
Rear no. 2 Seat assembly
Components ...

Disassembly
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove no. 1 Rear seat reclining cover lh Remove the 2 screws. Using ...

Other materials:

On-vehicle inspection
Inspect refrigerant pressure with manifold gauge set This method uses a manifold gauge set to locate problem areas. Read the manifold gauge pressure when these conditions are established. Test conditions: Temperature at the air inlet is 30 to 35°c (86 to 95°f). Engine is ...

General maintenance
Listed below are the general maintenance items that should be performed at the intervals specified in the “owner’s warranty information booklet” or “owner’s manual supplement/scheduled maintenance guide”. It is recommended that any problem you notice should be brought to the attentio ...

Multiplex communication circuit
Description The air conditioning amplifier communicates data with the ecm and combination meter through the can communication system. Wiring diagram Inspection procedure Check dtc Clear the dtc (see page ac-31). Read the dtc (see page ac-31). Result Go to can c ...

© 2011-2024 Copyright www.trav4.net