Toyota RAV4 manuals

Toyota RAV4 Service Manual: Removal

Caution:

Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1).

  1. Disconnect cable from negative battery terminal

Caution:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Remove glove compartment door assembly (see page ip-20)

  2. Remove front passenger airbag assembly

Toyota RAV4. Remove front passenger airbag assembly


  1. Detach the wire harness clamp from bracket.
  2. Disconnect the connector from the airbag.

Notice:

When handling the airbag connector, do not damage the airbag wire harness.

  1. Remove the 2 bolts from the reinforcement.
  2. Remove the instrument panel upper (see page ip- 6).

Toyota RAV4. Remove front passenger airbag assembly


  1. Release the front side airbag door from the front side hook by slightly bending it and lift out the front passenger airbag rearward.
  2. Release the rear side airbag door from the other hook and remove the front passenger airbag.
Front passenger airbag assembly
Components On-vehicle inspection Check front passenger airbag assembly (vehicle not involved in collision and airbag not deployed) Perform a diagnostic system check (see page rs- ...

Installation
Caution: Be sure to read the precautionary notices concerning the srs airbag system before servicing it (see page rs-1). Install front passenger airbag assembly Attach the rear side hook o ...

Other materials:

Operation check
Inspect driver side seat belt warning light Turn the ignition switch on. When the driver seat belt is not fastened, check that the driver seat belt warning light on the combination meter blinks. When the driver seat belt is fastened, check that the driver seat belt warning light o ...

Rear seat outer belt assembly
Components ...

Air mix damper control servo motor circuit (passenger side)
Description The air mix damper servo sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (passenger seat) to the appropriate position ...

В© 2011-2024 Copyright www.trav4.net