Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
Hint:
It is not necessary to fully remove the fender liner.
Partially remove it so that the bumper cover can be removed later.
Hint:
Use the same procedures described for the lh side.
Hint:
it is not necessary to fully remove the radiator support opening cover. Partially remove it so that the bumper cover can be removed later.
Hint:
Tape the screwdriver tip before use.
Hint:
Tape the screwdriver tip before use.
Hint:
Use the same procedures described for the lh side.
Windshield wiper de-icer
This feature is used to prevent ice from building up on the windshield
and wiper blades.
On/off
The windshield wiper de-icer will
automatically turn off after approximately
15 minutes. Pressing the
switch again also turns the de-icer
off.
Operating conditions
Vehicles without a smart ...
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove rear door scuff plate rh (see page
ir-29)
Remove package tray trim ...
Memory recall function (vehicles with a smart key system)
Each electronic key can be registered to recall your preferred driving
position.
Registering procedure
Record your driving position to button “1” or “2” before performing
the following:
carry only the key you want to register, and then close the driver’s
door.
If 2 or more keys ar ...