Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal

Toyota RAV4. Removal


  1. Remove radiator grille sub-assembly

  1. Remove the 4 bolts and 4 nuts.

Toyota RAV4. Remove radiator grille sub-assembly


  1. Detach the 6 claws and remove the radiator grille.
  1. Remove no. 1 Radiator grille lower

  1. Detach the 16 claws and remove the radiator grille.

Toyota RAV4. Remove no. 1 Radiator grille lower


  1. Remove no. 2 Radiator grille lower

Toyota RAV4. Remove no. 2 Radiator grille lower


  1. Detach the 16 claws and remove the radiator grille.
Ebxotdeyrior radiator grille (for 2gr-fe)
Components ...

Disassembly
Hint: When removing the ornament plate and emblem, heat the radiator grille, ornament plate and emblem using a heat light. Standard heating temperature Notice: Do not heat the radiator grille, ...

Other materials:

Rear no. 2 Suspension arm
Components Removal Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Remove rear wheel Disconnect no. 2 Parking brake cable assembly (see page pb-8) Disconnect skid control sensor wire (for 2wd) (see page bc-198) D ...

Front seat cushion heater
Inspection Inspect front seat cushion heater assembly lh Measure the resistance of the seat cushion heater. Standard resistance If the result is not as specified, replace the seat cushion heater assembly. Heat the thermostat with a light. Measure the resistance of the sea ...

Throttle / pedal position sensor
Hint: These dtcs relate to the accelerator pedal position (app) sensor. Description Hint: This etcs (electronic throttle control system) does not use a throttle cable. The app sensor is mounted on the accelerator pedal bracket and has 2 sensor circuits: vpa (main) and vpa2 (sub). This ...

В© 2011-2026 Copyright www.trav4.net