Toyota RAV4 Service Manual: Removal
Notice:
Do not heat the vehicle body, emblem and name plate
excessively.
Hint:
When removing the emblem and name plate, heat the vehicle
body, emblem and name plate using a heat light.
Standard heating temperature
- Remove no. 1 Back door emblem assembly
- Put protective tape around the emblem.
- Insert a piano wire between the vehicle body and
emblem.
- Tie objects that can serve as handles (for example,
wooden blocks) to both wire ends.
- Pull the piano wire and scrape off the double-sided
tape that holds the emblem to the vehicle body.
Notice:
- If reusing the emblem, take care not to
damage the emblem.
- Be careful not to damage the vehicle body.
- Remove back door name plate
- Put protective tape around the name plate.
- Insert a piano wire between the vehicle body and
name plate.
- Tie objects that can serve as handles (for example,
wooden blocks) to both wire ends.
- Pull the piano wire and scrape off the double-sided
tape that holds the name plate to the vehicle body.
Notice:
- If reusing the name plate, take care not to
damage the name plate.
- Be careful not to damage the vehicle body.
- Remove no. 1 Back door emblem
- Put protective tape around the emblem.
- Insert a piano wire between the vehicle body and
emblem.
- Tie objects that can serve as handles (for example,
wooden blocks) to both wire ends.
- Pull the piano wire and scrape off the double-sided
tape that holds the emblem to the vehicle body.
Notice:
- If reusing the emblem, take care not to
damage the emblem.
- Be careful not to damage the vehicle body.
- Remove no. 4 Back door name plate (for 4wd)
- Put protective tape around the name plate.
- Insert a piano wire between the vehicle body and
name plate.
- Tie objects that can serve as handles (for example,
wooden blocks) to both wire ends.
- Pull the piano wire and scrape off the double-sided
tape that holds the name plate to the vehicle body.
Notice:
- If reusing the name plate, take care not to
damage the name plate.
- Be careful not to damage the vehicle body.
Notice:
Do not heat the vehicle body, emblem and name plate
excessively.
Hint:
When installing the emblem and name plate, heat the vehicle
body, emblem and name plate using a heat light.
Standar ...
Other materials:
Throttle / pedal position sensor / switch "d" circuit range / performance
Description
Hint:
Refer to dtc p2120 (see page es-282).
Monitor description
When the difference between the output voltages of vpa and vpa2 deviates from
the standard, the ecm
determines that the accelerator pedal position (app) sensor is malfunctioning.
The ecm turns on the mil
and th ...
Automatic transaxle fluid
On-vehicle inspection
Check transaxle fluid level
Hint:
Drive the vehicle so that the engine and transaxle are at
normal operating temperature.
Fluid temperature:
70 to 80°c (158 to 176°f)
Park the vehicle on a level surface and set the
parking brake.
With the engine idling and ...
Unmatched encryption code
Description
This dtc is output when a key with an incomplete key code is inserted into
the ignition key cylinder.
Inspection procedure
Reregister key
Clear the dtc (see page ei-18).
Reregister the key code with the transponder key ecu
(see page ei-5)
Check that the engine ...