Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal
Hint:
When removing the spoiler, heat the vehicle body and spoiler using a heat light.
Standard heating temperature 
Notice:
Do not heat the vehicle body and spoiler excessively.
- Disconnect cable from negative battery terminal
Caution:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
- Remove back door center garnish (see page ed-59)
- Remove rear spoiler
- Remove the 3 bolts.
- Remove the 3 clips and spoiler.
- Disconnect the center stop light connector and remove the rear spoiler.
- Remove center stop light
- Remove the 2 screws and center stop light.
Ebxotdeyrior rear spoiler
Components
...
Installation
Hint:
When installing the spoiler, heat the vehicle body and
spoiler using a heat light.
Standard heating temperature
Notice:
Do not heat the body and spoiler excessively.
Install cent ...
Other materials:
Air conditioning filter
The air conditioning filter
must be changed regularly
to maintain air conditioning
efficiency.
Removal method
1. Turn the engine switch to
OFF.
2. Open the glove box and slide
off the damper.
3. Push in each side of the
glove box to disconnect the
claws, and then slowly and
fully open the glove bo ...
Removal
(2006/01- )
Remove front wheel
Drain automatic transaxle fluid
Drain the automatic transaxle fluid for u140f (see
page ax-147).
Drain the automatic transaxle fluid for u241e (see
page ax-146).
Drain the automatic transaxle fluid for u151e (see
page ax-172).
Remove front axle hub nut ( ...
Open in occupant classification ecu battery positive line
Description
Dtc b1794 is set when a malfunction is detected in the occupant
classification ecu battery positive line.
Wiring diagram
Inspection procedure
Check for dtc
Turn the ignition switch on.
Clear the dtcs (see page rs-249).
Hint:
First clear dtcs stored in the ...
