Toyota RAV4 Service Manual: Removal
Hint:
- Use the same procedures for the rh side and lh side.
- The procedures listed below are for the lh side.
- Remove roof rack support sub-assembly center
- Remove the 4 roof carrier caps and roof rack support center.
- Remove roof rack bar front
- Remove the 4 screws and roof rack bar.
- Remove roof rack leg cover front lh
- Remove the leg cover.
- Using a screwdriver, detach the 4 claws.
Hint:
Tape the screwdriver tip before use.
- Detach the rib from the bar.
- Detach the rib from the bar.
- Remove the leg cover.
- Using a screwdriver, detach the 4 claws.
Hint:
Tape the screwdriver tip before use.
- Detach the rib from the bar.
- Remove roof rack assembly lh
Remove the 4 bolts and the roof rack.
- Remove roof rack leg front lh
- Remove the 2 screws and roof rack leg front.
- Remove the leg cushion front.
- Remove roof rack leg rear lh
- Remove the 2 screws and roof rack leg rear.
- Remove the leg cushion rear.
Components
...
Installation
Replace roof carrier seal
Remove the seals.
Install new seals as shown in the illustration.
Install roof rack leg front lh
Install the leg cushion front.
Install the roof ...
Other materials:
Front wiper motor and link
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove front wiper arm head cap
Remove the 2 c ...
Blower resistor
On-vehicle inspection
Inspect blower motor control
Measure the resistance of the blower resistor.
Standard resistance
If the resistance is not as specified, replace the
blower motor control. ...
Check mode procedure
Description
Check mode has a higher sensitivity to malfunctions
and can detect malfunctions that normal mode
cannot detect. Check mode can also detect all the
malfunctions that normal mode can detect. In check
mode, dtcs are detected with 1 trip detection logic.
Check mode pro ...
