Toyota RAV4 Service Manual: Removal

Toyota RAV4 Service Manual / Exterior / Roof drip side finish moulding / Removal

Hint:

Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.

Remove roof drip side finish moulding lh

Remove the 2 roof drip moulding joint covers from the vehicle body.
Remove the roof drip side finish moulding and no. 2 Center roof drip side finish moulding.

Toyota RAV4. Remove roof drip side finish moulding lh

Notice:

Do not remove the clips from the vehicle body.
If the clips are damaged or removed b127947 accidentally, replace them.

Roof drip side finish moulding

Components ...

Installation

Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. When replacing the clip, heat the clip and body using a heat light. Standard he ...

Other materials:

Rear seat outer belt assembly
Components ...

Removal (2005/11-2006/01)
Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove roof headlining assembly Remove the roof headlining (see page ir ...

Communication malfunction no. 1
Description This dtc is output when a communication error occurs between the transponder key amplifier and transponder key ecu. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, or 2) noise is occurring in the communicatio ...