Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal

  1. Remove radiator support opening cover

  2. Remove front wheel rh

  3. Remove front fender apron rh

  4. Remove front suspension member reinforcement rh

  1. Remove the 4 bolts and reinforcement rh.
  1. Remove fan and generator v belt

  1. Using sst and 19 mm socket wrench, loosen the vribbed belt tensioner arm clockwise, then remove the fan and generator v belt.

Sst 09216-42010

Toyota RAV4. Removal


Notice:

On-vehicle inspection
Check fan and generator v belt Visually check the drive belt for excessive wear, frayed cords, etc. If any defect has been found, replace the drive belt. Hint: Cracks on the rib ...

Installation
Install fan and generator v belt Using sst and 19 mm socket wrench, loosen the vribbed belt tensioner arm clockwise, then install the fan and generator v belt. Sst 09216-42010 Not ...

Other materials:

Lumbar support adjuster assembly
Inspection Inspect lumbar support adjuster assembl Check operation of the lumbar support adjuster. Check if the lumbar support adjuster moves smoothly when the battery is connected to the lumbar support adjuster motor connector terminals. Ok If the result is not as spec ...

Front power seat control system
Parts location System diagram Problem symptoms table Hint: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected area" column of the table. Check each symptom by check ...

Multiplex communication circuit
Description The air conditioning amplifier communicates data with the ecm and combination meter through the can communication system. Wiring diagram Inspection procedure Check dtc Clear the dtc (see page ac-127). Read the dtc (see page ac-127). Result Go to can ...

В© 2011-2026 Copyright www.trav4.net