Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Removal

  1. Disconnect cable from negative battery terminal

Caution:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  1. Remove no. 1 Engine cover (see page es-410)

  2. Remove camshaft timing oil control valve assembly

  1. Disconnect the oil control valve connector.
  2. Remove the bolt and oil control valve.

Toyota RAV4. Removal


On-vehicle inspection
Check camshaft timing oil control valve assembly Check the operation. Connect the intelligent tester to the dlc3. Turn the ignition switch on. Turn the intelligent tester main ...

Inspection
Inspect camshaft timing oil control valve assembly Measure the resistance of the oil control valve. Standard resistance If the result is not as specified, replace the oil control valv ...

Other materials:

Only passenger door lock / unlock functions do not operate
Description The main body ecu receives lock / unlock switch signals and activates the door lock motor accordingly. Wiring diagram Inspection procedure Read value of intelligent tester (lock position switch) Use the data list to check if the door lock is functioning properly. ...

Maintenance requirements
To ensure safe and economical driving, day-to-day care and regular maintenance are essential. It is the owner’s responsibility to perform regular checks. Toyota recommends the following maintenance: General maintenance General maintenance should be performed on a daily basis. This can be done ...

Can communication system
Precaution Precaution Turn the ignition switch off before measuring the resistance of the main wire and the branch wire. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation. Before measuring th ...

© 2011-2025 Copyright www.trav4.net